Clean the rust off of an old lawnmower or mend its blade with a flush joint with this weld flux chipper and scaling tool in your kit. This powerful scraper delivers up to 4,800 blows per minute to force thick rust, old paint and dense welding flux off of the clean metal surfaces you're working on. The simple plate valve lets you throttle the mechanism for exacting control over the bit as you work.
Powerful and Fast
Drive rust and other contaminants clean off of your metal surfaces with this weld flux chipper and scaling tool. This effective scraper uses either of two bits to knock free the unwanted coating and uneven flux from old or freshly welded surfaces. The half-inch-square shank and 1.125-inch bore efficiently deliver force to the bit tip for maximum transfer of energy.
Dual Function
Use this weld flux chipper and scaling tool's flat bit for scraping rust and paint off of metal, then remove the needle attachment to start chipping down the messy flux at a weld joint. Transitioning between modes takes only a few seconds, so you finish your metalwork quickly.
Throttleable
This weld flux chipper and scaling tool's plate valve lets you control the chipper speed with a gentle change in pressure. Start slow to make initial progress against a rough surface, then crank it up to as high as 4,800 blows per minute for tough spots.
- Blows per minute - 4800 BPM
- Shank - 1/2 sq.in.
- Length - 18"
- Weight - 6.2 lb
- Air Flow - 15.5 CFM
- Min. Hose Size - 3/8"
- Air Inlet - 1/4" NPT
- Sound Level - 99 dBA
- Sound Power - 110 dBA
- Sound Power - 110 dBA
