No, Brother label makers do not all use the same type of tape. Different types of label makers require different types of label maker tape like TZe, Btag, M or DK. Also, different label makers support different maximum tape widths like 9 mm, 12 mm, 18 mm or 24 mm and higher depending on the specific model. Before purchasing your label maker tape, be sure to check whether it’s compatible with your Brother label maker.

To install label maker tape into a label maker, start by turning off the device and opening the rear or top compartment cover. Rotate the cartridge spool/wheel on the tape cartridge in the direction of the arrow to remove slack. Place the tape cartridge so the plastic guides and internal holes align inside the label maker. Gently press the cartridge until it snaps securely into place. Ensure the end of the tape passes smoothly through the guide, then snap the cover shut and print a test label.

To fix label maker tape that is loose, jammed or retracted into the cartridge, start by removing the cartridge from the label maker. Tighten any slack by turning the internal spool/wheel counterclockwise. If the tape is separated or stuck inside, try to guide the end cleanly back through the tape guides before reinserting the cartridge. If the label tape is wrinkled or torn, use scissors to cut the damaged portion.

To find out which label maker tape you need, find out the exact brand and model number of your label maker. It’s usually printed on the front, back or inside the cartridge door. Match the model to the manufacturer’s specific tape series, like Brother TZe or DYMO D1. Also, check the maximum tape width your machine supports, like 12 mm or 24 mm. If you have the wrong tape series or tape width, your label maker might not work properly.